Crown Molding

One of the most popular home improvement projects is to add crown moldings. Working with crown moulding is not one of the easiest projects but a little knowledge of the task at hand will help. Hopefully, you’ll find some good stuff about crown moulding here that will help you better grasp some of the terms and how to work with crown molding.

Have Questions? Call us at (888) 209-9307
We are happy to assist.

Click on the images below to find the crown molding perfect for your project

We produce crown molding for architects, contractors, installers and homeowners from any wood species as well as MDF (medium density fiberboard), plastic, flexible trim, and foam in any style or size up to 12″. Popular wood choices are mahogany, maple, poplar, red oak, cherry, and pine but many others are available.

How to Use Our Molding Search Tool
To begin a molding search, use the drop down menu (currently “Crown”) to select the type of molding. To see all available moldings in all sizes simply click “Start Search”. You can narrow the selection by entering dimensions in the fields.

Not sure what width, thickness or height or projection to enter?
Call us at (888) 209-9307 – or contact us.

How is Crown Measured?
Crown Molding Measurements

There are four measurements to be aware of when looking at a piece of crown. The width is the dimension at it’s widest point and the thickness is the thickest dimension when lying flat. The height is measured from the bottom of the crown where it meets the wall to the ceiling and the projection from where the face meets the ceiling back to the wall.

What is the Spring Angle on Crown Molding?
Crown Molding Spring Angle
The angle of the gap between the backside of the crown molding and the wall is called the spring angle and can be measured using a protractor. Crown molding angle is usually represented by two numbers of which the most common types are 45/45 and 52/38.

What is the Bevel?
The bevel is the tilt of the blade being used to make the cut.

What is the Miter?
The miter is the angle on the saw’s table.

Which End of the Crown Molding is Up?
Most crown molding features two distinct sections – a common element (a flat or curved area) and a more decorative element. The common element is called the “ogee” or “Cyma Recta” and the decorative element is called the “dentil.” In most installations, the dentil is considered the bottom part of the molding.

What if my Wall is Longer than my Moulding?
A scarf joint is used when you need to make an in-line straight connection between two pieces of crown molding. When cut properly, one section of crown molding will fit seamlessly over the other, like an overlapping joint.

What Size Nails Should I Use to Install Crown Molding?
For most installations 2″ finishing nails work best because drywall is usually 1/2″ thick and common crown moldings are 3/4″ or less thick. 2″ nails will allow the nail to enter the stud securely but prevent accidentally hitting any electrical wires which by code are installed along the center of the stud.

FIND CROWN MOULDING:

4″ to 6″ Crown Molding
6″ to 8″ Crown Molding
8″ to 10″ Crown Molding
10″ to 12″ Crown Molding
Bed Moulds
Cove Crown Mouldings

Not sure what size or style of crown molding or which
wood species is best for your project? We would love to assist.
Call us at (888) 209-9307 – or contact us.